Ripv1 — Test 1

Correct Answer: B. B. Debug ip rip
Explanation: The debug IP rip command is used to show the Internet Protocol (IP) Routing Information Protocol (RIP) updates being sent and received on the router. It verifies that the updates are being broadcasted and not multicasted.

Correct Answer: D. D. Both ripv1 and ripv2
Explanation: Both RIPv1 and RIPv2 support a maximum hop count of 15 because they use 4-bits to store this value. RIPv1 uses classful routing whereas RIPv2 uses classless routing. The routing updates are broadcasted over the network. It notifies routers about the update so that they update their own routing tables.

Correct Answer: A. A. Every 30 seconds
Explanation: RIPv1 router broadcasts its routing table every 30 seconds by default. The broadcasted routing table can be used by other routers to find the shortest path among the network devices.

Correct Answer: C. C. The route is inaccessible
Explanation: You cannot have 16 hops on a RIP network by default, because the max default hops possible is 15. If you receive a route advertised with a metric of 16, this means it is inaccessible.

Correct Answer: D. D. 1
Explanation: 1 is the default administrative distance of Static Route. It is used by routers to select the best path when there are different routes to the same destination. It’s used only two different routing protocols are being used.

Correct Answer: B. B. Rip
Explanation: RIP gives a full route table update every 30 seconds. The broadcasted routing table can be used by other routers to find the shortest path among the network devices.

Correct Answer: C. C. 120
Explanation: The default administrative distance is the default count of numbers assigned to arbitrary routes to a destination. The default administrative distance of RIP is 120. It is used to find the shortest route amongst the number of paths available.

Correct Answer: B. B. Use of variable length subnet masks is permitted
Explanation: Use of variable length subnet masks is permitted in classless routing protocols. Also use of discontinuous networks is allowed in such routing protocols. RIPv1 is a classful routing protocol but RIPv2 is classless routing protocol.

Correct Answer: A. A. On stub networks- which have only one exit path out of the network
Explanation: We must use default routing on stub networks. They have only one exit path out of the network, so there can be no specific path decided for such networks.