Civil Engineering Mcqs — Test 72

Page 1 of 3

Question 1

Shape factor is a property which depends________________?

Question 2

The mechanism method of plastic analysis satisfies___________________?

Question 3

The ratio of plastic section modulus to elastic section modulus__________________?

Question 4

Which of the following conditions is to be satisfied both in elastic and plastic analysis ?

Question 5

As per IS:800, in the plastic design, which of the following pairs are correctly matched? Working Loads Load factor________________?

Question 6

In case of plastic design, the calculated maximum shear capacity of a beam as per IS:800 shall be________________?

Question 7

The moment of inertia of the pair of vertical stiffeners about the center line of the web should not be less than__________________?

Question 8

For a compression member with double angle section, which of the following section will give larger value of minimum radius of gyration?

Question 9

A steel beam supporting loads from the floor slab as well as from wall is termed as________________?

Question 10

Hudson’s formula gives the dead weight of a truss bridge as a function of_________________?