Which type of Ethernet framing is used for TCP/IP and DEC net?

• A. Ethernet 802.3
• B. Ethernet 802.2
• C. Ethernet ii
• D. Ethernet snap

Consider a situation in which you are a system administrator on a NetWare network, you are running NetWare 4.11 and you cannot communicate with your router. What is the likely problem?

• A. Netware 4.11 defaults to 802.2 encapsulation
• B. Netware 4.11 defaults to 802.3 encapsulation
• C. Cisco routers only work with netware 3.11
• D. Netware 3.11 defaults to 802.2 encapsulation

NetWare IPX addressing uses a network number and a node number. Which statement is not true?

• A. The network address is administratively assigned and can be up to 16 hexadecimal digits long
• B. The node address is always administratively assigned
• C. The node address is usually the mac address
• D. If the mac address is used as the node address, then ipx eliminates the use of arp

Which NetWare protocol works on layer 3–network layer—of the OSI model?

• A. Ipx
• B. Ncp
• C. Spx
• D. Netbios

Which NetWare protocol provides link-state routing?

• A. Nlsp
• B. Rip
• C. Sap
• D. Ncp

As a system administrator, you want to debug IGRP but are worried that the “debug IP IGRP transaction” command will flood the console. What is the command that you should use?

• A. Debug ip igrp event
• B. Debug ip igrp-events
• C. Debug ip igrp summary
• D. Debug ip igrp events

What does the following series of commands “Router IGRP 71 network” accomplish? 10.0.0.0 router IGRP 109 network 172.68.7.0

• A. It isolates networks 10.0.0.0 and 172.68.7.0
• B. It loads igrp for networks 109 and 71
• C. It disables rip
• D. It disables all routing protocols

The “IPX delay number” command will allow an administrator to change the default settings. What are the default settings?

• A. For LAN interfaces, one tick; for WAN interfaces, six ticks
• B. For LAN interfaces, six ticks; for WAN interfaces, one tick
• C. For LAN interfaces, zero ticks; for WAN interfaces, five ticks
• D. For LAN interfaces, five ticks; for WAN interfaces, zero ticks

As a system administrator, you need to set up one Ethernet interface on the Cisco router to allow for both sap and Novell-ether encapsulations. Which set of commands will accomplish this?

• A. Interface ethernet 0.1 ipx encapsulation novell-ether ipx network 9e interface ethernet 0.2 ipx network 6c
• B. Interface ethernet 0 ipx encapsulation novell-ether ipx network 9e interface ethernet 0 ipx encapsulation sap ipx network 6c
• C. Interface ethernet 0.1 ipx encapsulation novell-ether interface ethernet 0.2 ipx encapsulation sap
• D. Interface ethernet 0.1ipx encapsulation novell-ether ipx network 9e interface ethernet 0.2 ipx encapsulation sap ipx network 6c

What does the “IPX maximum-paths 2” command accomplish?

• A. It enables load sharing on 2 paths if the paths are equal metric paths
• B. It sets up routing to go to network 2
• C. It is the default for cisco ipx load sharing
• D. It enables load sharing on 2 paths if the paths are unequal metric paths